Blendtec EXPRESS Instrucciones de operaciones

Page 8SECTION 5: OPERATING INSTRUCTIONS5.1 OPERATIONAL OVERVIEW1. Turn on the main power switch located on the back of the blender.2. Place the prope

Page 9the on position.● Unplug, then re-plug in the power cord.● Determine if the numbers on the Liquid Crystal Display (LCD) indicator are lighted.

Page 10BLENDED TEXTURE UNSATISFACTORY: If the blended texture of product is lumpy or uneven, do the following:● Make sure the mixture is not cavitatin

Page 115.6 LONG-TERM SANITATION OF JAR 1. For long-term sanitation, periodically ll the blender jar with hot tap water.2. Add non-chlorine sanitizer

Page 12● For long term storage of jar, apply a small amount of food-grade oil (such as vegetable oil) to the seals around the blade assembly both insi

Page 13SECTION 6: WARRANTY AND SERVICE PROCEDURE6.1 WARRANTY DESCRIPTION Blendtec warrants the Xpress for 1 year.JAR:The polycarbonate jar and inter

Page 146.2 SERVICE PROCEDUREShould you experience any difculty in using your Blendtec blender, please do the following:UNDER WARRANTY1. Contact your

Page 15

1206 South 1680 WestOrem, UT 84058801-222-0888www.blendtec.com OWN-CE-002 Manual for Xpress Blender Rev. 01 07/06

Page 1Table Of ContentsSection PageSection 1 ...Important Safeguards 2Section 2...Component Overview 4Section 3...Unpacking 6Sect

Page 2SECTION 1 – IMPORTANT SAFEGUARDS Read all instructions carefully before using your Blendtec machine.1.1 SAFETY CERTIFICATIONThe Xpress and acce

Page 31.7 THE 220/240 VOLT RECEPTACLE FOR EACH POWER UNIT MUST BE PROTECTED BY A SEPARATE 7.5 AMP OR GREATER CIRCUIT BREAKER OR FUSE. Do not use a

Page 4SECTION 2: COMPONENT OVERVIEW2.1 BLENDER MOTORThe blender motor consists of the motor, touch pad control, and Liquid Crystal Display (LCD) info

Page 5

Page 6SECTION 3: UNPACKINGSave the two foam inserts and all packaging for future storage or shipping. Save these instructions for future reference.3.

Page 7SECTION 4: INSTALLATION4.1 Xpress Installation1. Place blender on a at, clean, dry surface. 2. Make sure plug outlet is available within four